|
|
Mat Layout by John Figueras
This free ware program was written by John Figueras. It is helpful in calculating what your mat boarder should be.
If you like it give John an email j.figueras@verizon.net
Above is an image of the program. You must click the check mark below and open it or save it to make work for you. Enjoy |
The Overlap entry is the amount by which
the matte opening will overlap the image. The default is 1/8" (0.3 cm.). You
may change this value if you wish. Enter data
into the four input boxes, then click on the Compute button to display the
matte cutter settings required to produce a matte with the specified
dimensions. |
Thanks for the update John
 Click
the check mark to down load the program |